This is the emergency portable torch that I made in electronics tech. It took a couple of weeks but it was worth it, I never thought it was going to work but it did. There were 19 steps...... bend the corflute into a triangle, print out a photo of choice, glue it on, drill holes bid enough to fit LEDs, fit in LEDs, mark the - leg with red marker, add copper tape, mark the - and + sides to know which side is which, solder the + sides to the + copper tape, tin and solder wire onto the + legs that can't reach the + copper tape and solder them down, solder resistors on to the - legs and solder them down onto the - copper tape, make a hole big enough for a switch, add a switch into the hole, stick some double sided tape on the bottom, stick a batterie onto the double sided tape, add a batterie snap to the batterie, solder the + wire on the batterie snap to the switch, solder the - wire from the batterie snap on to the - copper tape, cut some more wire and solder it onto the + copper tape and the switch and hot glue the triangle corflute edges together, Switch it on and your done, it sounds quite complex but actually it's not that hard... apart from trying not to burn yourself. :)
No comments:
Post a Comment